- Home
- Resources
- Tech notes
- I2S audio interface basics
Tech notes
I2S audio interface basics
I2S signals (SCK, WS, SD, MCLK), standard, left-justified, right-justified and TDM formats, clock calculation, digital MEMS microphones, PCB layout tips and a debugging checklist — with timing diagrams and a clock calculator (in Korean)
The material opens in a frame kept separate from the website and does not connect to outside addresses
What this note covers
The material is in Korean. Select a chapter to jump to it in the viewer above
- 1 I2S란
I2S(Inter-IC Sound)는 보드 위의 칩끼리 디지털 오디오(PCM 샘플)를 주고받는 직렬 버스입니다
- 2 신호 네 가닥
컨트롤러와 타깃. SCK와 WS를 만드는 쪽이 컨트롤러(예전 용어로 마스터)입니다. 데이터가 어느 방향으로 가는지와는 상관없습니다 — 예를 들어 MCU가 클록을 만들고 코덱의 ADC 데이터를 받을 수도, 코덱이 클록을 만들고 MCU가 받기만 할 수도 있습니다. 두 칩이 모두 컨트롤러이거나 모두 타깃이면 소리가 나지 않습니다
- 3 타이밍과 형식
표준 I2S에서 WS는 MSB보다 한 클록 먼저 바뀝니다(1비트 늦춤)
- 4 클록 계산
BCLK = fs × 칸 비트 × 채널 · MCLK = 배수 × fs
- 5 디지털 MEMS 마이크 (I2S 출력형)
- 6 배선 요령 (PCB)
- 7 디버깅 점검표
- 8 승전 라인과 I2S
I2S를 쓰는 설계에서 승전이 공식 대리점으로 공급하는 라인입니다
Related notes
-
PWM and servo motor control basics
Duty cycle and average voltage, timer-generated PWM (frequency, resolution, center-aligned mode), choosing the frequency, RC filtering to a voltage, MOSFET and H-bridge drive with dead time, how RC servos work and pulse-width control, power and wiring, and a debugging checklist, with six diagrams and four calculators (in Korean)
-
Audio ADC basics — sampling, quantization and dynamic range
How sound and speech become numbers — sample rate and aliasing, speech bandwidths, bit depth and quantization noise, sigma-delta ADCs, reading SNR, dynamic range and THD+N, gain staging from microphone to ADC, clock jitter, synchronization and echo cancellation, and a debugging checklist, with six diagrams and six calculators (in Korean)
-
MEMS microphone basics — analog and digital (PDM)
How MEMS microphones are built and work, analog versus digital (PDM) output, what the specs mean — sensitivity (dBV/dBFS), SNR, THD, AOP, dynamic range, PSRR and more — acoustic-path resonance, circuit design and a debugging checklist, with cross-section and PDM diagrams and five calculators (in Korean)
Questions about this material?
Ask a SEUNGJUN FAE. Tell us the supplier and part number, and the team for that line will reply